05-09-2018 12:07 PM - last edited on 05-10-2018 01:08 PM by CherylO-Xerox
Good afternoon, a
lready at 7120 and 7220 I could set the output tray of prints and copies now at 7020 I can not. Can you help me, Carlos?
05-09-2018 01:14 PM
This forum is English only. Please use Google translate to post in English
EWS > Apps > Copy > General Settings and Policies > Output Destination
This needs a firmware newer than December 2017 though, so update to the one posted here first
05-09-2018 02:59 PM
Hi Joe, Carlos,
Just a little completion.
On VersaLink 7020 if is no finisher installed, the machine must have a center tray which on this model is an option and it must be purchased (497K18900 - center tray 2*250 sheets, dual catch tray).Otherwise it cannot be setup.
05-10-2018 10:18 AM
this is the problem,
All my versalink have two tray, and the setup don´t have anything to put, the only place that i saw was with finisher, but this is ??????????????