Support Community
Showing results for 
Search instead for 
Do you mean 
Reply
Occasional Advisor
Posts: 337
Registered: ‎02-13-2013

Re: Fiery X12 boot up issue

forget about printing from a pc for now. First make sure it can print internal fiery prints like a config page from the fiery buttons on the fiery lcd.

New Member
Posts: 7
Registered: ‎02-12-2018

Re: Fiery X12 boot up issue

 

Good question - no I'm not able to print Test page. Light on controller flashs a few times but nothing prints. Error ""network controller error" on DC 12 LCD screen.

 

Mark

Highlighted
Occasional Advisor
Posts: 337
Registered: ‎02-13-2013

Re: Fiery X12 boot up issue

Are the cables from the fiery to the copier hooked up right?

It could be a bad interface board on the copier of fiery side. These are the boards that the cables plug into.