Showing results for 
Search instead for 
Do you mean 
Reply
New Member
Posts: 1
Registered: ‎06-11-2014
Accepted Solution

Imaging unit and transfer belt on Phaser 6500

Yesterday I got an alert that says "ImagingUnit Life" "Replace Soon." This happened after a piece of Avery label peeled off and got wrapped around the black roller, which I noticed after a couple more sheets went through and had black all over them. I got the sticky stuff off the roller as much as I could, but not before it caused a dent in the transfer belt. This photo shows how it looks after I cleaned it with alcohol:

 

Imaging Unit damage1.jpg

 

So my question is: Are the marks I'm seeing on my pages caused by the imaging unit damage or are they caused by the dent in the belt? Or both? In other words, should I even try to salvage this printer at all? 

 

Thank you in advance.

Highlighted
Analyst Nation Moderator
Posts: 5,229
Registered: ‎11-25-2013

Re: Imaging unit and transfer belt on Phaser 6500

Marks would be caused by either/both, most likely, you would get twice as many defects in the print because the 2 defects won't line up identical on the page in reality.

 

Time to balance cost-to-fix vs cost-to-replace.

Please be sure to select "Accept Solution" and or select the thumbs up icon to enter Kudos for posts that resolve your issues. Your feedback counts!

Joe.