04-20-2017 09:57 AM
Looking to update the MOB unit. Sample prints show colors do not line up properly.
Is this something I can get and install myself?
Need part number if yes.
Solved! Go to Solution.
04-25-2017 06:37 PM
Thank you for using the Support Forum. THe only information I could find is Xerox® WorkCentre™ 7525 7530 7535 7545 7556 MOB ADC Assembly Part # 130K71470, but this part is not considered customer installable. Please consider contacting your support centre for further assistance.
04-26-2017 09:51 PM
The MOB sensor does not usually go bad. Color misregistration can be caused by a bad drum, developer housing, transfer belt or the MOB sensor which reads the patches on the transfer belt. I would try cleaning the MOB sensor first.
04-26-2017 10:13 PM
I had Xerox technician trained by Xerox company service the machine and the MOB unit needed replaced.
This is where I got my information.
How would I clean the MOB sensor? I am thinking the Xerox tech. already addressed that and summated the diagnosis.
Thank you for your time and knowledge.
12-16-2017 05:23 PM
Thank you for your input. I had technician install MOB unit. He made some adjustments and asked me if it looked okay. But, in fact, nothing has changed once I started production.
I remembered your input and now am reviewing. I think all four of my drums are relatively new, not sure how to check to see if one is bad.
The transfer belt is on its last bit of life and also the second bias transfer roller.
12-16-2017 09:09 PM
It would help if you knew which color was out of reg then you can focus on it. The tech can run internal test patterns to see. Replace the ibt assembly or swap drums around to see if the misregistered color changes.