Showing results for 
Search instead for 
Do you mean 
Reply
New Member
Posts: 1
Registered: ‎02-21-2014

Phaser 6500 Transfer belt changing

Hi guys, hoping somebody here has some guidance.

 

I've got a Phaser 6500 color laser printer, about 15,000 pages printer.  Print quality was bad so I got a new imaging unit, that helped.  Also got a new transfer belt.  That's where I am stumped, how do I swap this part out? 

 

It didn't have replacement instructions,and I can't seem to see the trick to getting the old one out from the pivot point at the bottom.  It looks like the metal pin on the toner side should move side to side.  On the opposite side is the driving gear & I don't see how to get that out either.  And of course the owners manual didn't have anything about changing it out either.  Any suggestions?  Otherwise it's been a great printer.

Thanks

Tony

Valued Advisor
Posts: 1,217
Registered: ‎07-23-2012

Re: Phaser 6500 Transfer belt changing

[ Edited ]

Hi you!

 

The reason why you cannot find any manuals on this is because an engineer is supposed to change the transfer belt on this machine, cause you will need to take it apart.

 

Removing both left and right cover, also using a screwdriver is needed on this machine to remove the transfer belt.

After removing the covers, and harness from the belt, unplugging the connector, pivot kit etc.

 

Best Regards

Kimzi


--------------------------------------------
Please remember to select "Accept as Solution" for posts that helped you solve the issue.

New Member
Posts: 2
Registered: ‎06-23-2014

Re: Phaser 6500 Transfer belt changing

After replacing the transfer belt you also need to reset the "Life DTB waste" parameter in the service menu parameter list (access service menu by holding down the up & down arrow keys while turning the printer on).

Member
Posts: 29
Registered: ‎08-18-2014

Re: Phaser 6500 Transfer belt changing

Hello everybody

 

Just changed transfer belt - machine was running with "transfer belt near the end of life"

 

got the same problem - and when I initialize "Life DTB wast" the counter does not go to zero but to 1.4M. and after restarting the machine the screen is blocked with "change transfer unit" massage Is theire a solution? Machine is  6505MFP at  60k prints;

 

Thank you in advance  

Highlighted
New Member
Posts: 2
Registered: ‎01-23-2018

Re: Phaser 6500 Transfer belt changing

I have the same on my printer.

I don't know what to do more ?

 

Help me please.

 

S.R.