09-26-2016 11:02 PM
I have a Phaser 6600 it will not start up. The Power light comes on and the Error light comes on.. both are on continuiously. there is not message in the display so I have no Fault codes. has anyone had this problem and can assit me in fixing it.
09-27-2016 02:23 PM
Haven't seen that , but try removing anything removable (Toner/Imaging Unit/ Waste cart etc) then turn it on. If any of them are the cause it will boot.
4 weeks ago
I am having the same issue. I've removed and reseated everything that can be taken out. I've also tried different outlets. The machine was working fine when last used. It's been idle for a ittle under two months. Is there a solution anyone knows of?