Support Community
Showing results for 
Search instead for 
Do you mean 
Reply
New Member
Posts: 5
Registered: ‎04-03-2018
Accepted Solution

Phaser 5550 only prints 10 pages then gives error.

The First two lines of the error read:

 

"ERROR: undefined (COMMAND TYPE: nametype)"

"OFFENDING COMMAND: selected pages: 1 10 "Selected pages: 1 10""

 

Windows 8 PC, printing from FreeFlow VI Design Pro. The first ten print just fine, any quantity higer and I get this error.

Analyst Nation Moderator
Posts: 5,889
Registered: ‎11-25-2013

Re: Phaser 5550 only prints 10 pages then gives error.

Since it happens with a Freeflow product you should post in its forum.

 

 

Please be sure to select "Accept Solution" and or select the thumbs up icon to enter Kudos for posts that resolve your issues. Your feedback counts!

Joe.
Highlighted
New Member
Posts: 5
Registered: ‎04-03-2018

Re: Phaser 5550 only prints 10 pages then gives error.

I will give that a shot as well. thing is, these same jobs print perfectly on our Phaser 4510.

Analyst Nation Moderator
Posts: 5,889
Registered: ‎11-25-2013

Re: Phaser 5550 only prints 10 pages then gives error.

But it won't be the printer, it is how the Freeflow interfaces, which is near always not the driver for the printer, and in that case you need to look at the print stream/PDL etc, which is simply not something most people can do, and I can't fake it, because the Freeflow stuff simply can't be replicated.

 

If the issue could be replicated with a driver, we could start looking into switching RAW to LPR to get a much smaller job size for instance, but even if that is the answer, I have no idea where in the FFPS to look.

Please be sure to select "Accept Solution" and or select the thumbs up icon to enter Kudos for posts that resolve your issues. Your feedback counts!

Joe.
New Member
Posts: 5
Registered: ‎04-03-2018

Re: Phaser 5550 only prints 10 pages then gives error.

Turns out the solution was that the new printer did not have VI Compose installed.