06-22-2017 07:25 PM
Recently acquired a digital printing press xerox 700 to join my collection of wide format printers. I am having a problem where I believe a light production finisher is leaving 2 embossed like marks accross the paper seems like from the roller. Is there any way to find out which one causes the problem and if so what should be done e.g pressure adjustment ?
I have attached 3 photos, one where I have added the green shade to show where the marks happen, second is a closeup, where marked with a pen and a third picture a back of paper see close under the shade near my hand is best I managed to catch the problem on the paper with a camera.
Photos in a folder below
btw. Hope is ok to link pictures from another website as the quite MB heavy to upload here.
06-26-2017 01:45 PM
Thank you for using the Support Forum. Please take a look at the solutions for banding on prints and copies. If these solutions do not help you please consider contacting your support centre for further assistance.
06-28-2017 04:33 AM
I got it fixed now, as promised will attach some photo later on of where the problem is so in the future someone may find it useful.
It was a a roller pressing too hard, so I loosen up a spring that holds the roller and applies a pressure.