Support Community
Showing results for 
Search instead for 
Do you mean 
Reply
New Member
Posts: 2
Registered: ‎04-07-2018
Accepted Solution

duplex printing is not aligned Workcentre 7835

When printing duplex, the printing on the front of the page is located higher on the paper than on the back.  It is about 1/8" off, meaning that if the two were to align, the front would have to move down on the paper by 1/16", and the reverse of the same sheet would need to move up 1/16".  Not a big problem, but I use this machine to print instruction manuals, and it is nocticeable.  This did not occur on the model 7535 which this 7835 machine replaces.

 

Is there an adjustment some where for this?

Highlighted
Frequent Member
Posts: 24
Registered: ‎02-19-2018

Re: duplex printing is not aligned Workcentre 7835

Hi,

It is a procedure in diagnostic mode (DC129 System Registration Setup), but this is available for service engineer so you need a tech.

New Member
Posts: 2
Registered: ‎04-07-2018

Re: duplex printing is not aligned Workcentre 7835

thanks for the prompt answer. :)