I need instructions on how to build job in an email.
I have obtained an instruction manual. Followed the steps on pages 111-112
If Build Job is enabled, when prompted, do these steps.
• To change settings for the next segment of the document, touch Program Segment.
• To scan another page, load the new document onto the document glass, then touch Scan Segment.
• To finish, touch Submit.
There is NEVER a Submit button. NEVER. I get an endless loop of Program Segment/Scan Segment screen.
AND--as I scan in a segment, it doesn't show on that screen as a segment.
However, when I go to leave--I get all sorts of warning about losing my job--which I can't see and which I can't send anyway!
Is this a glitch in need of repair or am I missing something? My experience with Xerox is there is often a step, some button you need to push, that is never mentioned in the instruction manual which will make it work properly.
Yes there sounds like something a little strange going on, so I would recommend contacting the Support Department to do some troubleshooting with you. The Support options for your device are listed here.
Either your printer firmware is really out of date or its a serious glitch.
Any Current firmware (Starts with 101) and the interface is as described.
The Submit option isn't hard to find.
So update your printer with this firmware