cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
New Member
New Member

Error: Your job cannot be accepted now. Please try again later

Jump to solution

When trying to fax to our network server or scan to a network directory we get ther error message:

Your job cannot be accepted now. Please try again later

After a few seconds the ADF kicks in and takes your document and either scans it to the directory or faxes it (confirmation ok). The error message comes with a close button. If you hit it, you see the fax number isn't cleared even though the fax was accepted. I am at the current software version 20.105.01.010. I have been experiencing this with the past few software updates. I cannot say that one of the updates caused it.

 

We have tested the internal hard drive and it tested good. When you run a copy, there is no issue. We have changed our network entries for the scanning and fax to IPs. We still get the same results. We have also swapped the ADF with one from a known working unit. problem still persists.

 

I have searched the knowledgebase and the forums and cannot find anything.Has anyone else experienced this?

0 Kudos
2 Replies
Highlighted
New Member
New Member

Re: Error: Your job cannot be accepted now. Please try again later

Jump to solution

This is a Xerox 3635MFP

0 Kudos
Highlighted
New Member
New Member

Re: Error: Your job cannot be accepted now. Please try again later

Jump to solution

Figured it out...

 

Date and time was set in the past... looking or NTP settings if I can use them... I corrected the date and time and it is working!

0 Kudos