cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
New Member
New Member

Need to change the baud rate and ECM on a WorkCentre 5325

I even have the service technician manual and I cannot type in the NVM codes as it does not provide them!

 

Can anyone provide me with the NVM codes for this?

 

Thanks,

 

JH

0 Kudos
2 Replies
Highlighted
Valued Advisor
Valued Advisor

Re: Need to change the baud rate and ECM on a WorkCentre 5325

here you go : 

 

826-159 ECM capability (Auto error resend function) When line error occurs during sending, resend is automatically started when error is fixed 1= Enable, 0= Disable 1
826-162 T1Timer value at receiving 1 to 90, default is 39 Seconds 39
826-216 Channel1 G3 RX Modem Speed receive communication speed capability (Capability of other than V.34) V17: 8= 14400, 6= 9600, 5= 7200, 1 to 8 8
826-217 Channel2 G3 RX Modem Speed receive communication speed capability (Capability of other than V.34) V17: 8= 14400, 6= 9600, 5= 7200, 1 to 8 8
826-218 Channel3 G3 RX Modem Speed receive communication speed capability (Capability of other than V.34) V17: 8= 14400, 6= 9600, 5= 7200, 1 to 8 8
826-222 Channel1 G3 RX Modem Speed receive communication speed capability (Capability of V.34) V34; 14= 33600, 1 to 14 14
826-223 Channel2 G3 RX Modem Speed receive communication speed capability (Capability of V.34) V34; 14= 33600, 1 to 14 14
826-224 Channel3 G3 RX Modem Speed receive communication speed capability (Capability of V.34) V34; 14= 33600, 1 to 14 14
826-228 Channel1 G3 TX Modem Speed max. value (Send)(Capability of other than V.34) V17: 8= 14400, 6= 9600, 5= 7200, 1 to 8 8
826-229 Channel2 G3 TX Modem Speed max. value (Send)(Capability of other than V.34) V17: 8= 14400, 6= 9600, 5= 7200, 1 to 8 8
826-230 Channel3 G3 TX Modem Speed max. value (Send)(Capability of other than V.34) V17: 8= 14400, 6= 9600, 5= 7200, 1 to 8 8
826-240 Channel1 G3 TX Modem Speed max. value (Send) (Capability of V.34) V34; 14= 33600, 1 to 14 14
826-241 Channel2 G3 TX Modem Speed max. value (Send) (Capability of V.34) V34; 14= 33600, 1 to 14 14
826-242 Channel3 G3 TX Modem Speed max. value (Send) (Capability of V.34) V34; 14= 33600, 1 to 14 14

0 Kudos
Highlighted

Re: Need to change the baud rate and ECM on a WorkCentre 5325

Hi....I remember running Ardurover on a vanilla raspbian jessie image some time ago. Ardurover does not need fast stabilization calculations, so it worked alright. I did this with a Navio+ and I do not know if the Navio2 needs further changes to support the RCIO chip.

0 Kudos