SMTP settings for scan to email

[Joe Arseneau · Accepted solution]

smtp.office365.com

port - 587

STARTTLS for encryption (Not STARTTLS (If Available))

Authentication is ON and set it as On Device

Make sure you have the latest firmware

And if it still won't work, do this

And Change from Dual Stack to IPv4

If that doesn't work, there is an issue in the Time/date/DNS/Gateway or Proxy settings outside of the Email stuff.

I have never in my life seen a fault code even similar to 30088-4, nothing about the way it is formatted implies a Xerox device is in use.

[JLeslie]

Setup a new Versalink C505. All is working except for scan to email. Since I haven't found any specific instructions on what the settings should be, I've just been trying all sorts of combinations of settings. But after each change the test fails with error code 30088-4.

I'm going through Office 365 and so using an O365 account to send from. I can login to OWA with the account so it's verified to be a valid account.

Does anyone have any idea what the SMTP settings should be to send out scans from email when using an O365 account? Server address is smtp.office365.com as Microsoft says to use. I've tried port 25 and 587. For security I've had it off, Starttls, and SSl/TLS. I've tried with SMTP Authentication on and off. For validation type I've tried both On Network and On Device.

So I'm at a loss as to what the settings all should be. Hopefully someone here know.

Thanks