VersaLink A3 - increase or reduce output size

[kaika313]

Hi Joe,

thank you, it worked!

Karina

[Joe Arseneau · Accepted solution]

t doesn't show sizes because it doesn't really need to.

Put the A4 paper in the feeder, select the tray with A3, set reduce/enlarge to Auto

It will enlarge to fit. Instead of showing pictures of the redundant steps that Connectkey products do, it just takes the input and compares it to the output size to figure out the size. Which is fine most of the time, the only benefit Connetckey/AltaLink had was that when you selected a reduce enlarge option it showed the percentage, and from that you could finesse it later by increasing/decreasing the percentage by a few percent if desired.

[kaika313]

Hi,

I'm sorry for the real banal question but I can't figure out where we can find increase or reduce output size for copy.

I mean if I have for example an A4 document and want to copy it on a A3 sheet of paper how can I do it?

It was so simple with ConnectKey software...!

The only thing I can see now is increase/reduce by percentage or automatic.

Could you help me please?

Thank you

Karina