cancel
Showing results for 
Search instead for 
Did you mean: 
6 Replies
RandyD
Frequent Member
Frequent Member

Re: Adjusting for creep in imposition

EFI Application
Randy Devost | Wearer of many hats :)
0 Kudos

Re: Adjusting for creep in imposition


@Orandrean154 wrote:

Typically, that would be a function of your imposition software. In Preps, for example, it's simply a matter of putting in the amount of creep you want for the center spread and Preps figures out the math for the rest.


Any Update???

0 Kudos

Re: Adjusting for creep in imposition

Typically, that would be a function of your imposition software. In Preps, for example, it's simply a matter of putting in the amount of creep you want for the center spread and Preps figures out the math for the rest.

0 Kudos
DavidU54339-XRX
FreeFlow Production Workflow Moderator
FreeFlow Production Workflow Moderator

Re: Adjusting for creep in imposition

"Impose 5" is not a term I am familiar with. Is this an EFI application? Something else?

0 Kudos
RandyD
Frequent Member
Frequent Member

Re: Adjusting for creep in imposition

I'm using Impose 5 on a C60 with EX Rip. If I want to dial custom numbers am I entering in the sheet thickness in inches?

Randy Devost | Wearer of many hats :)
0 Kudos
JyriS-Xerox
FreeFlow Production Workflow Moderator
FreeFlow Production Workflow Moderator

Re: Adjusting for creep in imposition

You use the Signature Shift option under the imposition setup to add creep. You can give a specific value or use the media thickness option to specify this.

 

SignatureShift.png

TBall_Sydney
FreeFlow User

Adjusting for creep in imposition

Does anyone create impositions that allow for "creep" in a saddle stitch booklet and if so what is your method?

 

 

0 Kudos