cancel
Showing results for 
Search instead for 
Did you mean: 
famaller New Member
New Member

assymetic Impossition of single PDF file

Hi

I like to create a asymmetric imposition of a 70mmx150mm job on a SRA3. it is one PDF or PDF/VT file from XMPie.

To fill the paper I like a 2 by 4 group in one end of the sheet and a 2 by 2 group in the other end of the sheet and it needs to by cut and stack

My question can this we done with FFCore, and what module will I need to have. I have advanced Prepress

I would like to upload a drawing of the imposition if needed.

REgards

 

Niels-Martin

 

0 Kudos
4 Replies
FreeFlow Production Workflow Moderator DavidU54339-XRX
FreeFlow Production Workflow Moderator

Re: assymetic Impossition of single PDF file

I do not understand the rationale/requirement behind the 2 groups. FFCore impostion node may be able to meet your requirements. Below is a screen snap of the node with a setup that may approach whay you are looking for.assymetric.png

0 Kudos
n-m_aller
FreeFlow User

Re: assymetic Impossition of single PDF file

I do not know the specific purpose of the layout. I will ask for the reason.

But supposing there is a reason behind it, can it be done?

 

Regards

 

Niels-Martin

0 Kudos
FreeFlow Production Workflow Moderator DavidU54339-XRX
FreeFlow Production Workflow Moderator

Re: assymetic Impossition of single PDF file

I'm going to need to better understand the imposition layout before I can give an opinion on FFCore capabilities. An attached diagram would be a big help.

Regards,

Dave

0 Kudos
Highlighted
famaller New Member
New Member

Re: assymetic Impossition of single PDF file

There were no reason for the impossition layout, thanks for challenging it.

Regards

nm

0 Kudos