Hi
I like to create a asymmetric imposition of a 70mmx150mm job on a SRA3. it is one PDF or PDF/VT file from XMPie.
To fill the paper I like a 2 by 4 group in one end of the sheet and a 2 by 2 group in the other end of the sheet and it needs to by cut and stack
My question can this we done with FFCore, and what module will I need to have. I have advanced Prepress
I would like to upload a drawing of the imposition if needed.
REgards
Niels-Martin
I do not understand the rationale/requirement behind the 2 groups. FFCore impostion node may be able to meet your requirements. Below is a screen snap of the node with a setup that may approach whay you are looking for.
I do not know the specific purpose of the layout. I will ask for the reason.
But supposing there is a reason behind it, can it be done?
Regards
Niels-Martin
I'm going to need to better understand the imposition layout before I can give an opinion on FFCore capabilities. An attached diagram would be a big help.
Regards,
Dave
There were no reason for the impossition layout, thanks for challenging it.
Regards
nm