700 Digital Color Press Device Failure 042-326

[digitalprintplus]

Yep I did reset the NVM value but nothing has change the error still comes up.
And don't want to do it 3 times in a row cause as you say the print mode will become disabled

[GabiE-Xerox]

Have you reset the NVM value? Because if the fault appears 3 times in succession the print mode will be disabled.

[digitalprintplus]

Thanks much. We have cleaned the assembly some toner spillage etc.
But still having the same error.
In fact we basically cleaned the entire machine. Still the same error.
I've ordered a new belt cause not sure if it's the belt it either lands on Monday or Tuesday.
I think we saw the sensor on the unit and cleaned it but no luck.
Hoping it's just the belt and not full unit

[GabiE-Xerox]

Hi,

The belt edge sensor is located inside the IBT assy, on the back side at the bottom of the assembly and it is a little optical sensor. But the problem become from the reflective patch who can be peeled, worn, wrinkled, or damaged and you can clean or replace it if you have some similar.

Gabi

[digitalprintplus]

Good day where is this sensor located? 

[Kawai]

Hey,

 I had same problem. Remove the belt, clean belt home position sensor and clean home patch inside belt. If belt is already streched/old, then replace it and of course clean sensor.

Greetings

[CanarcticPress]

Transfer belt

[soport1211]

On the Xerox 700 Digital Color Press, what does a 041-345 fault code mean? 1. Check the front door and the toner door are both closed. 2. If that doesn't do it try powering..Any solution for this?

[vicky]

What code releases the controller after changing the belt?

[vicky]

What code do you need to put into the controller to release the code after cleaning/changing the belt?