Showing results for 
Search instead for 
Did you mean: 
MarcinM New Member
New Member

Błąd 010-346

Witam. Proszę o informację co to za błąd 010-346 i czego dotyczy?

Drukarka włącza się, pokazuje ten błąd na panelu i prosi o restart lub kontakt z administratorem.

Drukarka Xerox VersaLink c405


Nie znalazłem wyjaśnienia w instrukcji użytkownika ani nawet w google.


Z góry dziękuję za pomoc. 


Tags (2)
0 Kudos
1 Reply
Analyst Nation Moderator Joe053204-hcl
Analyst Nation Moderator

Re: Błąd 010-346

010-346 Temperature detection of the NC or STS sensor did not change after the main lamp was on for over 15 seconds


Actually fixing this will require a service tech though, usually the fault can be cleared by just un-plugging it for 5 minutes, but when that fails, you are left diagnosing wiring to the fuser and some PWB's in the area, with a multimeter.

Please be sure to select "Accept Solution" and or select the thumbs up icon to enter Kudos for posts that resolve your issues. Your feedback counts!

0 Kudos