Fiery X12 boot up issue

[Joe Arseneau]

CWS can be run on any PC, it doens't need to be done on the Fiery.

You need an old version, probably CWS4.

[mkeane]

Thanks Joe,

Followed the instructions, got to the restore option and got it back up and running. But...

Getting a "network controller error" - told I need to install a patch via the CWS. I think I have the right patch but I cannot get into NT to run CWS.

Do you know how I can get into NT ? Have a screen attached of course.

Any ideas ?

Thanks again,

Mark

[Joe Arseneau]

The X12 is the bustled Fiery, it runs a custom Linux (With no GUI) with EFI Fiery software.

The XP12 is a Windows XP PC running the EFI Fiery software.

If you no longer have the original install disks you are probably out of luck.

Take a look here and here

[mkeane]

Hi,

We have a Fiery X12 connected to a DocuColor 12 (circa 2005 !). When powering up it stays at "Configuring HD controller..." and then goes to "Loading...". I have a screen attached and I see a "Boot Failure" message (see full message below). 

I don't know how to fix this issue - do I need to re-install the OS on the server ? Is it Windows XP ? Is there Fiery software then to install ?

Would really appreciate some comments, suggestions, prayers etc !

Mark

Boot Failure
Reboot and Select proper Boot device
or Insert Boot Media in selected Boot device
Press any key when ready