CWS can be run on any PC, it doens't need to be done on the Fiery.
You need an old version, probably CWS4.
Followed the instructions, got to the restore option and got it back up and running. But...
Getting a "network controller error" - told I need to install a patch via the CWS. I think I have the right patch but I cannot get into NT to run CWS.
Do you know how I can get into NT ? Have a screen attached of course.
Any ideas ?
The X12 is the bustled Fiery, it runs a custom Linux (With no GUI) with EFI Fiery software.
The XP12 is a Windows XP PC running the EFI Fiery software.
If you no longer have the original install disks you are probably out of luck.
We have a Fiery X12 connected to a DocuColor 12 (circa 2005 !). When powering up it stays at "Configuring HD controller..." and then goes to "Loading...". I have a screen attached and I see a "Boot Failure" message (see full message below).
I don't know how to fix this issue - do I need to re-install the OS on the server ? Is it Windows XP ? Is there Fiery software then to install ?
Would really appreciate some comments, suggestions, prayers etc !
Reboot and Select proper Boot device
or Insert Boot Media in selected Boot device
Press any key when ready