The Maintenance kit was replaced but within the menus, it still says the maintenance kit is end of life. When I selected maintenance kit, there was no reset button in the top right as mentioned in the manual. I have been told it also says the kit was partially replaced. Anyone else had this message before?
Your help in this matter would be most appreciated.
Thanks in advance.
You can't expect to get an answer until you at least tell what device has the error
I have a VersLink405 and I have recently replaced transfer unit, phazer unit, toners and waste container. It has been a month and I am now receiving an End of life warning for 108R01122. Phazer now says 20% remaining. Is there a way to reset the count or end of life warning? Please advise if you require further information.
Thank you for your assistance.
@Joe Arseneau wrote:
You can't expect to get an answer until you at least tell what device has the error........krogerfeed
Hold down MENU until PCL CONFIG MENU appears. Press the MENU key until SERVICE MSG=ON* appears. Press the + or - key to change display to SERVICE MSG=OFF. Press ENTER/RESET MENU key to turn message off, the * should appear, then press ONLINE.