thank you but we've already followed those instructions, as we did for the previous machine that in fact worked without problems.
I think that there's a bigger problem, like the one that affected VersaLink products... but maybe I'm mistaking.
Thank you anyway
Please take a look at the information in the article about tips for resolving communication issues with Remote Services. If those suggestions do not help then please consider contacting your support centre for further assistance.
thank you, the article you mentioned did solve the problem for VersaLink products but not for PrimeLink.
The new machine (B9100) with the same settings of a previous D95 which was communicating does not work even with the 'cloning trick'. Maybe there's something different to do with PrimeLink series?
Thank you for using the Support Forum. Please take a look at this article about the issue you are having. The article will give you a little more detail and an explanation about what caused the issue. If this does not resolve the issue for you, please consider contacting your support centre for further assistance.
just clone and install it? Without nothing else?
Ok, I'll give it a try...
Yesterday, I had two B7035 units from two different customers that would not connect to Remote Services...
I was advised by 2nd Level Support to Clone the device, then install the clone...
that fixed the problem...
are there any known issues with latest Versalink firmwares and Xerox Remote Services?
We have a new Versalink C505 in an office and a C7025 in another location and both, with latest available general firmwares, have problems connecting to remote services.
It's not an issue regarding network because in both locations previously installed printers (both WorkCentre series) with same settings were able to communicate with Xerox. Also checked all typical settings (DNS, Date & Time, IP, etc...) and set them as old machines...
What can I do?