I've been trying to resolve this 116-331 error message on my own using existing discussions on this forum, but haven't been able to figure it out. Has anyone experienced this error on startup? I've followed the on-screen instructions with no success. When I enter the diagnostic I find that IOT 2 in the NVM will not initialize... no idea what that means but it may be helpful to someone here.
The HDD needs to be initialized, which is done via the diagnostics menu (Special boot mode)
The directions for which are Xerox Confidential, so they cannot be disclosed on the forum.
So either a service technician needs to be dispatched, or you need to obtain a Service manual.
Sorry I can't be of more help in this case.
Yes I had exactly the same problem on my Versalink C600, thought it was broke for good and it's virtually new with only 1/4 for the original toner cartriges used.
Found out if you turn it off then press both buttons when you turn it on, it opens in a special sort of mode which allows you to do a memory reset.
Worked after that except the WIFI did'nt register so I turned it off again, took out the WIFI module, turned it on and off again then put the WIFI module back in and it was all OK again.
after that I updated the Xerox software on my PC and Firmware on the printer, been OK since.
Hi - has anyone found a solution to this? I have managed to get into the diagnostic menu by sheer luck, so i can navigate the display but no idea what to do. Have called xerox service and they are trying to provide me with a quote for a service, but so far no one has gotten back with one. I really need to sort this out asap as its keeping me from doing important work. Any tips please?
I have to say your tips worked well. Although on mine I did both reboots, the HDD Initialize did not work but the Storage Device Intitialize Mode reboot worked. Thank you for the help.