WorkCentre 78xx series, cannot select metric custom paper size from bypass

[TammyL-Xerox]

Hello kaika313, 

I see no one has responded to this post yet. So, at this point I would recommend contacting your local Xerox Support Department to speak with a Product Specialist for more assistance.

[kaika313]

Hi,

are there any known issue about selecting custom paper size for bypass tray on WorkCentre 78XX series?

When loading a non-standard sheet of paper (e.g.320mm x 43 mm) on bypass and when custom paper size is selected even if Metric is selected for paper preference I can only see measures in inches and this make very difficult to select proper values.

Is it a firmware (075.010.010.12010) problem or anything else?

Anywhere but there in custom paper size e I can see Metric measures...

Thank you