CLOSE CONTROL PANEL MESSAGE PHASER 8560

[Mitchell889923-xrx]

Hi hawker71,
Thank you for using the Xerox forum.

This message can indicate that other assemblies aren't seated as described in the following:

Solutions for : Close Control Panel Message

http://www.support.xerox.com/support/8560MFP/support/en_US.html?objGUID=5165

There are also other solutions there that may be helpful to indicate potential problems when searching the product support site for this error message.

If that does not resolve your issue you may consider contacting our specific product support experts at the following link:

Fast Track to the Expert

[hawker71]

Replaced the exit assembly due to jame errors then after installing new part I start getting "Close Control panel ALARM 

if anyone ran into this or can help i would appreciate it

Thanks