cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted

Finisher on Color 560 not folding the correct fold

I'm attempting a 4/4 8.5"x11" trifold project on my Color 560. I run everything through the Fiery software on my Mac OS 10.11.3, and tell it to make a trifold. It comes out as a Z fold, but it's not even a correct Z fold. The second fold leaves the back edge with an inch and a half of paper outside the folded area (not folded symmetrically).The settings in Fiery have been triple checked and are correct. I don't know what to do to even begin to fix this. I've tried different papers/weights which had no effect.

 

We ran a job similar to this last week, with no issues. I don't know what has changed. Same settings.

 

Help.

 

JJ

0 Kudos
1 Reply
Analyst Nation Moderator Joe053204-hcl
Analyst Nation Moderator

Re: Finisher on Color 560 not folding the correct fold

After it is printed, does it still show tri-fold in the properties of the job when it hits the printed queue in CWS5?

I have never heard of getting a Z-fold half sheet in place of a tri-fold, this is a first.

Screen Shot 2016-04-20 at 1.52.14 PM (Small).png

 

 

If copies do the same, I would think you could just adjust the fold via Machine Status > Tools > System settings > Common Service settings > Maintenance > Finisher Adjustment > Adjust Fold Position

 

 

 

Please be sure to select "Accept Solution" and or select the thumbs up icon to enter Kudos for posts that resolve your issues. Your feedback counts!

Joe
0 Kudos