cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
digitalprintplus Valued Member
Valued Member

Fuser roller tends to need changing rather fast

Product Name: Xerox Color C75 EFI Fiery Controller
Operating System: Windows 7

Hi ther eguys, 

Withing two months of so of using the fuser I have to be changing the fuser roller because you would see the plastic begin to rise and it begins showing on the prints

I instealled new fuser June 14 and mid last week we began seeing the marks show up on the prints on a roller we change liek a month ago

0 Kudos
5 Replies
gabiene Advisor
Advisor

Re: Fuser roller tends to need changing rather fast

Hi,

Have you replaced just the fuser roller or entire fuser? Because the fuser roller is not a genuine part. And those marks can appear from frequent paper jam, or improper eliminating the jammed paper.

digitalprintplus Valued Member
Valued Member

Re: Fuser roller tends to need changing rather fast

Well from the last fuser I've put in on June 14, I've already had to replace the roller once since then and due to put in another one in a few days.

 

Yeah I'll go with the paper jams and improper way the paper might be pulled diring jams so i'll be sure to let the guys know

thanks

 

0 Kudos
gabiene Advisor
Advisor

Re: Fuser roller tends to need changing rather fast

If you intend to replace the roller take care when manipulating it, because is very sensitive, even a touch can scratch it. Also pay attention at the gap between the fuser roller and the stripper blade. This gap should be small as possible (you can measure it with paper cardstock about 120 gsm) . The gap can be adjusted from the 5 little screws. And take a look at the pressure belt to be in proper condition. An used pressure belt can damage the new fuser roller.

digitalprintplus Valued Member
Valued Member

Re: Fuser roller tends to need changing rather fast

Thanks so much for your assistance, will make sure to monitor this and let the tech know when doing the installation. thanks again
0 Kudos
godfather36 New Member
New Member

Re: Fuser roller tends to need changing rather fast

good morning to me think u should check the papers u are using and the cards make sure u are suing the right onces thank u

0 Kudos