Paper Jam in the GBC

[digitalprintplus]

I'm geting a jam 040-100 in the GBC

Now the paper isn't flying under the latch where it should go

[GabiE-Xerox]

Possible causes:

-Unpluged entrance GBC sensor

-Defective GBC PWB (5volts missing)

-GBC Power Supply defctive (24V missing)

[GabiE-Xerox · Accepted solution]

Also check the GBC power cord and switch.

[digitalprintplus]

I know it boots lol. 

If it's a power supply or so missing I'll just remove it lol. We dont' use that part more than maybe 5 times a year. My staff just loves doing those booklets manually lol don't know why

But thanks @gabiene for your response as usual

I'll try the plugs again I know I unplugged everythign behind there once but if they aren't running as should would just remove at least will get back some much needed space. 

[digitalprintplus]

The cable was unplugged. We had done some work in the back and had unplug all the cables and my dumb,... Didn't plug all back in so Ky faul
But decided to just removed the unit as we were being crammed for space after getting a second printer in plus installed some shelving. So everything worked out for a good :)