No DNS Response (ND18) error still happening about once a day.
I printed the TCP/IP Runtime log for the printer, i saw the following: (after running network diagnostics)
pinging the default gateway
No ping response from default gateway xxx.xxx.xxx.xxx, AND no ARP entry
no response to ICMP router solicit
No ping response from primary Name Server xxx.xxx.xxx.xxx, AND no ARP entry found
End diagnostics status:0 error:18 msg:Name Server Response
Packets up protocol stack 0 over 1086 seconds
End diagnostic status:0 error:26 msg:No packets delivered to protocol stack
are there any specific settings that need to be selected at the DNS server?
do i need to add the printer to the DNS or AD list?
if so, how do i add it? (win server 2003)
I am not to sure how the DNS could bring down the IP address. We are leaving aside the hosts and focus on the IPs.
You can try 2 things if you want to continue try to understanding the problem.
Apart from this you can also not configure DNS on the printer. If you do so make sure the IP addres you have on the printer TCP/IP settings is not register on any DHCP scope so that DNS is not being broadcasted by DHCP.
Apart from all this, if you think those steps are a bit waste of time, then you can go straigh into a network trace, neverthless if the problem is physical with the Xerox printer it will be hard to check it on the Trace, as it will nly show the packets drop.
some times i also get a "bad ethernet cable (ND27)" error, but i have tested and changed the network cable several times, also checked the cable from my printer to the switch
After a reboot the printer does connect back to the network, lately, it stays in the network for under 10 minutes.
when it disconnects, the PCs connected to it get a pop up error mesage saying "printer status is not available at this time, you can close this or wait"
no specific actions, we havnet really been printing to this printer because of the problem, but im always monitoring it on centreware.
when i realize the printer has gone down, i can still ping the printer successfully for like a minute, then after the minute, the ping returns a "destination host unreachable"
once the printer drops, nothing else can connect to it, no printjobs, no centreware, no pings, and this is in several PCs.
i have been thinking that it is some of our DNS server settings that are doing this like you said. Do you have any ideas that i can try with the settings?
It is possible that the lack of DNS registration would break connectivity, nevertheless that configuration would have to come from you network and not from the Xerox device. Putting this apart, lets try to understand a bit more the problem.
From what I understand from yous post the problem is that the printer drops off the network.
Couple of questions:
I have a phaser 8560MFP set up in a network. about 18 computers on the network, all with static IPs, same as the printer. We also have a DNS server running.
The printer ofter drops off of the network, and when i run the printer's network diagnostics, it comes up with the error "No DNS Response (ND18)" and some other times it has the error "Packets Jammed (ND26)".
the printer was working fine until about the middle of january, and its been acting up ever since.
we even got a replacement printer from xerox after a lot of troubleshooting.
we also have a Phaser 8560DN on the same network, which has no problems at all.
Testing and troubleshooting:
i have updated the firmware to the latest version 4.9.4.
i have moved the printer to a new IP address, and only connected to it about 5 PCs, all of these PCs have been wiped clean of old drivers, and freshly installed latest drivers with the "install from web" version of the "global printer driver" version 5.185.41 which installs driver version 188.8.131.52N 2011.01.31
nothing has worked yet, we believe it could be an issue with the DNS server, but dont know what.
Solved! Go to Solution.