My printer is brand new, I've done a setup to enable Wifi only, tried the connectivity by scanning a document and send it by mail, everything went fine. The firmware is up to date.
As expected, when I don't use it, it turns into sleep mode. The problem is I have no way to wake it up :
The only way to use it again it to unplug the power (reboot the hard way....) and I know for sure it's not the best way. Altough I didn't bought a printer to partially do the job ;)
I'm very disappointed. I don't have any access to the printer internal logs so I can't check by myself what's happening (is it the network ? Wifi only seems not to be straightforward to setup so I wonder if it's native...)
Do you please have any clue on what's happening ?
Thank you :)
Solved! Go to Solution.
I bet it isn't actually up to date firmware, just the latest General Release firmware (65.50.61)
Then, in the power saver you should get this option which will stop the sleep issue when enabled
What happens is, the WiFi option is attached on the USB bus, and by default, the USB port shuts down to save power, so it (the wifi adaptor) can't wake the printer back up (Because it isn't actually there anymore)
I have a WorkCenter 6515 but when I give it the bin file linked in this solution it says its not for the 6515.... I feel like this is definitely what's going on.