Hey folks, I just wondered if anyone can help with our issue?
We recently had a fuser issue where a piece of paper ending up caught in the printer and damaging the fuser, though I beleive the fuser was on the way out anyway.
The fuser was easily replaced, but now we find that the printer will not pick up from Tray 1. We get a error saying that Tray 1 is empty, but before this the printer emits a number of clicks as though something is jamed. The bypass tray works fine btw. The printer has been thoroughly checked and there are no obstructions.
At the same time we had the paper jam issue we also needed to replace the paper in Tray 1, but on trying to remove the Tray we found it also jamed. Eventually we removed the bypass tray and pushed a lower part of Tray 1 down to remove it from teh printer. I assume the issues are linked? But I don't understand why the fuser issue would have effected the paper pick-up, unless it's pure coincidence and we we unlucky enought to have had two issues at the same time?
The printer has only ever done light office work in a clean enviorment and has only done approximatly 40,000 prints in about 5 years, so not a great deal of work.