The words "just install the latest firmware on Xerox.com" is a link in the post to a much newer version than the 34540 release you are seeing. In fact it is 10 levels behind current, only General release information is available via search, so unless you click on my link I provided, you won't get the latest firmware.
And for the driver/Xtools, again, click the link and click the only driver available at it "AS400 Workstation Customization Object Library for Xerox Products" and it will show you the file name is indeed XTOOLS
We got a WorkCentre 6655, not a 6655i (this was a free replacement as our Phaser 8560 died so we didn't have a choice of model.) They are exactly the same printer, the only difference is that the ones with the "i" came with firmware that starts with 073, the non-i-series came with firmware that starts with either 071 (Connectkey 1.0) or 072 (Connectkey 1.5) And the firmware are all free updates, so if you want an iSeries, just install the latest firmware on Xerox.com
The printer works fine except will not print from the AS400 (iSeries). We keep getting the message "operator action required on device devname (c r)" on the AS400. While searching for a solution, I came across http://www-01.ibm.com/support/docview.wss?uid=nas8N1019526 titled "Information on Printers from Xerox and Fuji Xerox". Within it, it is stated "This document contains information on the capabilities that are supported on printer hardware from Xerox." and "Most PCL printers use port 9100 and regardless of the hardware, a PCL Manufacturer Type and Model, such as *HP4, *HP5SI, *HP4000, etc. will work."
I stopped the printer, varied it off, changed the type and model to *HP4, varied it on, started it and we still get the error. I rebooted the printer after this change, too, and that did not help either. Has anyone else run into this and have any suggestions?
