cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
New Member
New Member

Xerox Phaser 6700 Fan error

Dear, 

 

I have problem with phaser 6700 its show fan error when printing sometimes, i replace that fan with new one and same problem i have...

 

Fault code is 

310.398.01 Engine Fan Failure

Tags (3)
0 Kudos
1 Reply
Valued Advisor
Valued Advisor

Re: Xerox Phaser 6700 Fan error

Hey you!

 

the code means that A failure was detected in the Fuser Fan.

 

Here's what it says in the manual :

 

Initial Actions
• Check for obstructions or accumulations of dust or debris blocking fan
rotation.
• Cycle system power.
• If the problem persists, follow the procedure below.

 

Fan Alarm tests turn On the target Fan, then check for the Fan’s Alarm signal
returning to the MCU Board.

Parts:
■ Fuser Fan, PL4.1.8
■ Harness RH Cover, PL4.3.16
■ MCU Board, PL10.2.18
■ Harness RH Motor, PL11.2.3
■ “Map 3 - Right Door” on page 10-7
■ “Map 5 - MCU Board and Laser Unit” on
page 10-9


1 Test the Fuser Fan Alarm signal
using dc330 (010-210).
The Fan Alarm state is Off.
Replace the
MCU Board
(page 8-152).
Go to Step 2.
2 Replace the Fuser Fan (page 8-71).
The error persists.
Visually inspect
and test
continuity of all
applicable
harnesses
Complete.

 

Hope this helps

 

Best Regards

Kimzi


--------------------------------------------
Please remember to select "Accept as Solution" for posts that helped you solve the issue.

0 Kudos