error code 042-326 from C75

[digitalprintplus]

We have tried that in fact the first print, sorry didn't take a photo thee black came out a little light and then we had another print with a logo with black with it same thing

then a few more

I think this have happened before I think it just went away, but I'd see what hapens 

And yeah was with normal paper

[GabiE-Xerox]

Hi,

It is just an unfused print, not a problem with toner or developer. Try a normal print with proper paper settings.

[digitalprintplus]

Happening to my black prints only

don't know if there's something wrong with the toner

[digitalprintplus]

Hi Gabi, 

it all  workled out

I didn't see that NVM value you sent before so was entering one fouind elsewhere and it never workd

We put in the new belt and it's working great

even a line in the blue (cyan involved) prints used to come up with a line on the page

but that's gone now

Thing though black we are having some issues with black and not sure if it's coming from a toner spillage or so cause one the toner doors (where you enter the toner in sometimes stays open

and we are having an issue with black prints

where it's liek the black colour is not being fused to the page. 

[GabiE-Xerox · Accepted solution]

Hi,

First try to reset in Diag mode in NVM the value 741-132 to 0. If this did not work try to clean the little silver reflective patch located  inside the belt.

Gabi

[digitalprintplus]

We looked it up found what the error was

Thing is where is this sensor located?

Or is **bleep** the belt?

I ordered a belt hoping it gets to the island by Monday but in the meanwhile it could just very well be on the sensor 

We had to change a drum so wondering if while putting back in the assembly if it touched off something, during that time we had the belt protected.