We have tried that in fact the first print, sorry didn't take a photo thee black came out a little light and then we had another print with a logo with black with it same thing
then a few more
I think this have happened before I think it just went away, but I'd see what hapens
And yeah was with normal paper
It is just an unfused print, not a problem with toner or developer. Try a normal print with proper paper settings.
Happening to my black prints only
don't know if there's something wrong with the toner
it all workled out
I didn't see that NVM value you sent before so was entering one fouind elsewhere and it never workd
We put in the new belt and it's working great
even a line in the blue (cyan involved) prints used to come up with a line on the page
but that's gone now
Thing though black we are having some issues with black and not sure if it's coming from a toner spillage or so cause one the toner doors (where you enter the toner in sometimes stays open
and we are having an issue with black prints
where it's liek the black colour is not being fused to the page.
First try to reset in Diag mode in NVM the value 741-132 to 0. If this did not work try to clean the little silver reflective patch located inside the belt.
We looked it up found what the error was
Thing is where is this sensor located?
Or is **bleep** the belt?
I ordered a belt hoping it gets to the island by Monday but in the meanwhile it could just very well be on the sensor
We had to change a drum so wondering if while putting back in the assembly if it touched off something, during that time we had the belt protected.
Solved! Go to Solution.