115R00115 Fuser Past End of Life - Replacement Required?

[corisys]

Hi Tammy

Thanks for your reply, that answers my question perfectly. 

Best wishes

Lee

[TammyL-Xerox · Accepted solution]

Hello corisys, 

I searched our knowledge base and found this article for Fuser Past End of Life for you to review.  If you are still having questions, I suggest that you call into our support department for assistance @ 1-800-821-2797.

[corisys]

Hello

Just a quick question, one of our VersaLink C7025 has had a message on for the past 6 months advising:

Fuser R8 Past End of Life

The printer is functioning without any issues, no printing issues so far. 

We have just replaced all 4 Drums that once they had gone down to 0% the printer stopped printing completly until all 4 Drums were replaced. 

My question is, as there are currently no printing issues, will the Fuser also count down to 0% and stop the printer from functioning until the Fuser is replaced?

I do not see a reason to replace the Fuser until we start seeing printing issues.

FYI Total Impressions 167352

Thanks in advance

Lee