cancel
Showing results for 
Search instead for 
Did you mean: 
New Member
New Member

2100 Tray alignment issues.

I have been having issues with the tray alignment and paper weights.

 

From what I understand, I need to setup each paper size and weight for each tray.  When I open the tray and put paper I change the stock in the library.  When I go the alignment and select the tray and paper size it asks me for a different weight and says there is a mismatch.  I have 2 machines, yesterday 1 was asking for a cardstock weight I never use and today the other one is asking for normal paper (I have the drawer setup with cardstock). 

 

 

How am I supposed to setup a tray with the cardstock settings that I use if it won’t accept the paper that in the tray?

 

OR

 

Am I doing something completely wrong?

 

 

 

Thanks,

Chris

Tags (1)
0 Kudos
1 Reply
Highlighted
Valued Advisor
Valued Advisor

Re: 2100 Tray alignment issues.

I'm a little lost here. What is asking for particular stocks and when?

 

Command Workstation doesn't care what the stock is, just the try and size, the stock type comes from what is in the printer.

 

1.GIF

 

Auto-Alignment (Used with SIQA typically) again lists exactly what was programmed when the tray was loaded.

 

2.GIF

 

Manual alignment doesn't care, but you can apply it to the tray by name , so you could call an alignment "Cardstock" and apply it to the tray only when you loaded the stock.

 

3.GIF

 

 

4.GIF

 

You assign it to your stock/tray as such after you select Change Settings

 

1.GIF.

 

2.GIF

 

In short, tell me exactly what you are doing and in what, then I will at least attempt to figure out where it has gone wrong.

Please be sure to select "Accept Solution" and or select the thumbs up icon to enter Kudos for posts that resolve your issues. Your feedback counts!

Joe Arseneau
0 Kudos