cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
New Member
New Member

6204 error 123-315

We have a wide format printer that is giving us a Chain Link Error 123-315.

 

What can I do to fix this?

0 Kudos
3 Replies
Highlighted
Valued Advisor
Valued Advisor

Re: 6204 error 123-315

123-315 RAP
BSD-ON: CH3.7 ESS
CTS Internal Failure (UI-Control panel). UI software error within the ESS PWB.
Procedure
CAUTION
The Accessories have their own power cord. Whenever a procedure states to Power Off and
then Power On, POPO, etc., powering Off and then powering On the IOT does NOT Power Off
the Accessory. The Accessory will have to be Powered Off and then On separately from the
IOT by unplugging the Accessory power cord.
Switch the power Off, then on. If the problem still exists, perform the following:
1. Upgrade ESS Firmware to the latest version (GP 2) and check to see if the same problem
is repeated.
2. If the problem continues, replace the UI Interface PWB (PL 11.5).
3. If the problem continues, replace the ESS PWB (PL 11.6).

Please be sure to select "Accept Solution" and or select the thumbs up icon to enter Kudos for posts that resolve your issues. Your feedback counts!

Joe Arseneau
0 Kudos
Highlighted
Member
Member

Re: 6204 error 123-315

hello how about error 71-940 (xerox 6204)

0 Kudos
Highlighted
Valued Advisor
Valued Advisor

Re: 6204 error 123-315

Open and close the rear door.  Make sure the machine is in a climate controlled environment. Fault 071-940 RFC 1 Jam or Error, check for an jammed paper or paper pieces. 

Please be sure to select "Accept Solution" and or select the thumbs up icon to enter Kudos for posts that resolve your issues. Your feedback counts!

Joe Arseneau
0 Kudos