On my brand new Workcentre 6515 Avery address labels print about 1/8" too low from either the bypass or main tray. It causes print to go off the bottom.
I originally had left the paper set to "plain" and it was off nearly a 1/2". Its like the label sheet is slipping when its fed and not staying place.
If I print the same label document on plain paper it is perfectly aligned. Is there some way to correct the misfeeding?
If you haven't already fixed the aligment issue with labels, I suggest you try searching our online knowledge base for a solution.
Alternatively, you can visit our Contact Us page for other support options.