On my brand new Workcentre 6515 Avery address labels print about 1/8" too low from either the bypass or main tray. It causes print to go off the bottom.
I originally had left the paper set to "plain" and it was off nearly a 1/2". Its like the label sheet is slipping when its fed and not staying place.
If I print the same label document on plain paper it is perfectly aligned. Is there some way to correct the misfeeding?
Hello,
If you haven't already fixed the aligment issue with labels, I suggest you try searching our online knowledge base for a solution.
Alternatively, you can visit our Contact Us page for other support options.