We have a workcentre 6515 and recently we have been getting a black line down the right hand side of the page. I have done the transfer rolller and belt clean multiple times from the printer menu but it is still there. I have changed the black toner also.
When you open the back of the printer you can see the mark on the transfer belt which I have tried wiping away but it just comes back.
Solved! Go to Solution.
OK thanks do you have any idea how I do this as I can't seem to take anything out from the back apart from the transfer roller?? And I can't find any videos for this model
1. Open the Waste Cover.
2. Remove the Waste Cartridge,
3. Open the Rear Cover.
4. Release the lever on each of the CRU Drum Cartridges (Y,M,C,K).
Figure 1 Handle Locations on the Transfer Belt Unit
5. Refer to Figure 2 to remove the four screws attaching the Transfer Belt Unit and remove
the Transfer Belt Unit from the rails. Remove only the screws seated against the metal
frame as shown in the figure.
After thar locate the blade cleaner, remove and clean it. Normaly you need a tech for this procedure.