Booklet stapling wrong place

[Jeff2]

Please what was the NVM values? I have the same issue with my xerox J75. After I adjusted and save, the values of the fold and staple settings the machine reboots and when I run the booklet print job the changes has no effect and it still doesnt stable on the fold. Please help.

Thanks

J

[Jeff2]

Please what was the NVM values? I have the same issue with my xerox J75. After I adjusted and save, the values of the fold and staple settings the machine reboots and when I run the booklet print job the changes has no effect and it still doesnt stable on the fold. Please help.

Thanks

J

[Jeff2]

Please what was the NVM values? I have the same issue with my xerox J75. After I adjusted and save, the values of the fold and staple settings the machine reboots and when I run the booklet print job the changes has no effect and it still doesnt stable on the fold. Please help.

Thanks

J

[digitalprintplus]

yeah I had to do what you suggested plus also put the NVM values for the specific book sizes to 0

then go to the setting in admin and change the settings until it folded and stapled in the right place 

thanks much 

[Joe Arseneau · Accepted solution]

It should be adjustable around Machine Status > Tools > System Settings > Common Service Settings > maintenance > Finisher Adjustment > Adjust Fold Position.

I used to have a machine and there was an option in or near that location that included lining up the staple with a multipage fold.

[digitalprintplus]

ny assitance would be greatly appreciated thanks 

[digitalprintplus]

Hi there guys I'm working on a booklet but the staples are going in the wrong area

I did get some assitance on how to get the booklet folded in half because it wasnt doing so so i adjusted teh setting in NVM but I'm still getting the stapled in the back on the book and not in the fold. thanks