Hello jhuber,
This setting should be in the printing preferences of the drivers, if it's missing I suggest calling into the support department @ 1-800-821-2797 to speak with an software analyst to make sure your using the correct driver.
How does the print driver decide if a document printed from the bypass tray is printed Long Edge Feed (LEF) or Short Edge Feed (SEF)? There doesn't seem to be a setting in the Windows 10 driver to select this.
Normally, If I print to the bypass tray, the C7030 asks for SEF. In Word, I've set up a page of Avery 5167 labels, and when I print those to the bypass tray, the C7030 asks for the labels in the bypass tray to be LEF.
Why does the C7030 asks for the labels LEF? The 5167 label sheet has very small labels that need precise placement. I actually get better placement if the label sheet is fed through SEF (if I print it as "Plain" type), but then the sheet goes through very fast.
Also, the little diagram on the bypass tray shows that envelopes with the flap on the long edge should be fed LEF, and evelopes with the flap on the short edge should be fed SEF, but how does one tell the driver to do that?
Thanks!
Thanks!