I've replaced the fuser assembly, replaced all developers, toners and still I'm having this issue.
I can't believe this machine can't work as expected.
I think it just need to be printed even more slow or hotter than the actual values and I can't figure it out how to do that, all chain links related to smear prints don't solve this issue.
Such a pain in the ...
I couldn't find anything about adjusting the fuser temp like on our Phaser products. I did find two articles for you to review below that may be of assistance.
If you are still having issues after trying these steps, I suggest that you call into our support department for assistance @ 1-800-821-2797 or 1-800-835-6100
How to enable the Banner Page.
Hi, thanks for reading, I'm having a printing issue that I can't find how to solve:
I usually print different types of papers with different weights for different purposes; including bond paper, coated cardstock, adhesive paper, and heavyweight coated cardstock.
The fault occurs when I usually print multiple copies of a file with a lot of graphics, even with the correct settings, the toner comes off the sheet, I tried to change the setting to a heavier type of media, but it only works for light and medium papers in some cases; but for heavy papers like heavyweight cardstock this method rarely works.
Is there a way how to reset or reconfigure the fuser to increase the temperature or decrease the fusing speed, like phaser series does? also, Why I can't print Banner sheets like Phaser series does too?
I currently use the glossy heavywheight cardstock type for all the media I print, since it is the only way I waste less paper and toner as possible.
Thanks for your comments.