Configuration Report

[CathyO-Xerox]

Hello selleypet,

Here are some steps that may help you:

Enable or Disable Configuration Page at Start Up

1. Press the [Machine Status] button on the Control Panel.
2. Press the [Up] or [Down] arrow button until "System Setup" is selected, and then press the [OK] button.
   
   NOTE: If prompted, enter the Administrator password. The default password is "1111" or the device serial number
   
   
3. Press the [Up] or [Down] arrow button until "Machine Setup" is displayed, and then press the [OK] button.
4. Press the [Up] or [Down] arrow button until "Configuration Page" is displayed, and then press the [OK] button.
5. Select "On" (enabled) or "Off" (disabled) , and then press the [OK] button.
6. Press the [Stop] button to return to Ready mode.

If this does not resolve the issue please consider contacting your support centre for further assistance.

[selleypet]

For my Xerox WorkCentre 3025 printer, I want to turn it off so that it does not print a Configuration Report every time I turn it on.