cancel
Showing results for 
Search instead for 
Did you mean: 
gabiene Frequent Advisor
Frequent Advisor

Re: Cyan toner on prints

Jump to solution

Those on the bottom of the fuser module with  springs.

0 Kudos
digitalprintplus Valued Member
Valued Member

Re: Cyan toner on prints

Jump to solution

oh ok cool got you thanks

0 Kudos
digitalprintplus Valued Member
Valued Member

Re: Cyan toner on prints

Jump to solution

Hey man we tightened the screws to your settings but didnt' work so think had to go to liek 15 turns

didn't use the NVM settings yet cause the prints have improved enough

 

on another note 

these photos check the marks opn the paper I'm wondering if that's coming from the transfer belt

yeah only show on the larger pages

20180809_191253.jpg20180809_191247.jpglet me know we had an issue with the belt once and changed it (yeah you should remember because you had tell us what the error was) then I think when was going on it wa knicked a bit. 

If that's the issue now which the marking seems to be very clearer now since we adjusted the fuser

Another thing the red tint whihc started showing up is gone after changing the drum so we changed both the cyan and magenta drums must say the prints are really good with the exception of that markings, and we got tons of business cards to run 

0 Kudos
gabiene Frequent Advisor
Frequent Advisor

Re: Cyan toner on prints

Jump to solution

It looks like the fuser roll have an scratch on it. If the distances between marks are 110 mm, it became from fuser.

0 Kudos
digitalprintplus Valued Member
Valued Member

Re: Cyan toner on prints

Jump to solution
Ok thanks I will check this.

And now there is magenta lines running down the prints. Always one thing to the next. Will upload those prints when I get behind a computer
0 Kudos
Highlighted
digitalprintplus Valued Member
Valued Member

Re: Cyan toner on prints

Jump to solution

This is what I'm getting now. We were having a problem with the magenta on the paper which you suggested we change the drum. We have I did soem colour adjustment well I did the sampe magenta print and I saw a heavy thick magenta print on the paper.  I checked previous prints and realise it was there but light, mainly cause these were regular 32lb prints. 

so I rant a few more and this is how it's showing up

If you realise the black has improved tremendously ( the tech reset the screws back to the original position, and I changed the NVM, so might turn the screws 4 times just to make sure) 20180809_205827.jpg20180809_204157.jpg

0 Kudos
digitalprintplus Valued Member
Valued Member

Re: Cyan toner on prints

Jump to solution

@gabiene wrote:

It looks like the fuser roll have an scratch on it. If the distances between marks are 110 mm, it became from fuser.


I measured the distance and got like 4.33 inches approx 110mm from the end of one mark to the next or the beginning of one mark to end of next 

so I;ll change the fuser roller and see thx again

0 Kudos