I setup a PIN on a Xerox Phaser 6600 a while back and I thought I wrote it down but I didn't and I can't remember this anymore. I am also not able to log in to the web console as my credentials are not accepted although I'm pretty sure I'm typing them correct as I use the same for all printers and have used them in the past.
Is there a way to recover from this? is it possible to restore the printer to factory default?
Solved! Go to Solution.
Try booting while holding down Up + Down arrows to get to the service menu
find the "RESET NVM" menu., might be in "Maintenance mode"
Thank you, that helped resolve the issue. There was an option "Clear NVM" which did the trick.
I know this is old stuff, but everything is detailed in the FAQs here:
If a password has been set and it has been lost, then Network Defaults will need to be reset on the printer to remove the password from CWIS. See the Related Content for additional information.
The above refers to:
(and all other settings to factory defaults, procedure pasted below)
To reset network defaults: