Freeflow Accxes installation/recovery cd iso download

[spfaff]

Had an FRX controller failure here that is connected to a 510 wide format.

Replaced the FRX pc with another of the same configuration (Dell Optiplex 745).

Installed the original interface card and  Freeflow Accxes installation/recovery cd Ver. 5.0 b100.

When I try to install the 12.7 or 13.1 firmware that supports the 510 I get "download not allowed" messages on the console, (See below).

Pretty sure I either need a version of the Firmware compatilble with the 5.0 cd OR another iso of a version below 5.0.

I see reference to v 4.4.

Does anyone have a download link for either of the above?

0x95b1db90 (tEmTask): ====== Firmware Update  ==== 
0x95b1db90 (tEmTask): Comparing kernel 2.6.22.9-61.fc6 to list value 2.6.22.9-61.fc6
0x95b1db90 (tEmTask): Found a kernel match! 
0x95b1db90 (tEmTask): <validateCD> Detected CD version:  5.0.  Version required by download: 3.2
0x95b1db90 (tEmTask): processFirmwareDnld.c @(#)processFirmwareDnld.c	$Revision: 1.46.4.1 $: 4028
0x95b1db90 (tEmTask): ******************************************************************
0x95b1db90 (tEmTask): <validateCD> CD Rev 3.2 is LESS THAN 5.X.  NOT Allowing download.
0x95b1db90 (tEmTask): 
0x95b1db90 (tEmTask): This Accxes dnld requires CD version greater than 3.2 and less than 5.0
0x95b1db90 (tEmTask): 
0x95b1db90 (tEmTask): ******************************************************************
0x95b1db90 (tEmTask): processFirmwareDnld.c @(#)processFirmwareDnld.c	$Revision: 1.46.4.1 $: 4545
0x95b1db90 (tEmTask): Skipping update...Current error: -175
0x95b1db90 (tEmTask): ====== End Update Section ====

Thanks much for any help,

Steve

[CherylO-Xerox]

Hello spfaff.

If you have not already resolved this issue, we suggest you search our online knowledgebase for this product: FreeFlow Accxes Control.

Alternatively, you can visit our Contact Us page for other support options.

[sherifgis]

in my opinion you need to install version 4.4 . i can send you iso copy for it but please i need copy for v5.0 can you send me image .

[ManWithHands]

can u send iso image 'Accxes Recovery CD' for me to?
I need to recover Hard drive on Accxes(HFT) controller from Xerox 8825, but i have no CD..
Thank you!

[Comanche]

Can you help me too?

I need install/recovery cd v4.4 for Accxes Xerox 6204

[marcus_aurelius]

Did you find install/recovery cd v4.4 for Accxes Xerox 6204? I might need that also. The version 5 I have is not working for me.

[Comanche]

No, I didn't find v4.4. Can you share 5? I'll try to adapt it

[marcus_aurelius]

Sure. Send via dropbox maybe?

[Comanche]

ок, you can use dropbox  or google disk or mega

[marcus_aurelius]

You you have experience with the problem I am having?