cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Mikefrompittsford Frequent Member
Frequent Member

How to plug in sata hard drives on Creo connected to docucolor 250

Jump to solution
Product Name: Docucolor 250 Creo
Operating System: Not Applicable

 

I took the drives out of my creo in order to back them up, but I now seem to have forgotton where to plug the three sata cords back in.  I plugged the three wires into the three spots circled and it seems to work fine, but I'm fairly confident that is not where they were originally plugged in.  Does it matter?  Please notice that one of the drives was marked system.  Thanks for any help in advance!

(The way they are actually plugged in is the way I THINK they were plugged in originally, but not all three drives are recognized when I plug in that way.) 

 

 

InkedIMG_1174_LI (2).jpgIMG_1178.jpg

 

Tags (1)
0 Kudos
2 Replies
Analyst Nation Moderator Joe053204-xrx
Analyst Nation Moderator

Re: How to plug in sata hard drives on Creo connected to docucolor 250

Jump to solution

Due to it being SATA, it shouldn't matter where they are plugged in.

I believe the drive that gets used as the print spool is not accessible in Windows, but it is simply too long ago to remember if that is for sure.

I have a CX260, but it is entirely different apparently, as seen here, and while not helpful, they are hooked up bottom left, bottom right, upper right (going out to in on the drives)

1.JPG

Please be sure to select "Accept Solution" and or select the thumbs up icon to enter Kudos for posts that resolve your issues. Your feedback counts!

Joe.
Mikefrompittsford Frequent Member
Frequent Member

Re: How to plug in sata hard drives on Creo connected to docucolor 250

Jump to solution
Thanks Joe! Great info as always.

Hopefully someone out there has a 250 to solve this for me.
0 Kudos